Cranegard

Clamps on cables for wire rope hoist, elevator and crane overload prevention and slackline detection. Installs in minutes with screwdriver and Allen wrench. Installation is simplicity itself. Clamp the Cranegard® directly onto a slack hoist or crane wire rope quickly without severing rope or interrupting service. Up to four switches can be furnished. Switch actuates immediately when pre-set load limit is exceeded. Dillon will set the switches to trigger at the loads you desire, if specified at time of order.

Clamps on cables for wire rope hoist, elevator and crane overload prevention and slackline detection. Installs in minutes with screwdriver and Allen wrench. Installation is simplicity itself. Clamp the Cranegard® directly onto a slack hoist or crane wire rope quickly without severing rope or interrupting service. Up to four switches can be furnished. Switch actuates immediately when pre-set load limit is exceeded. Dillon will set the switches to trigger at the loads you desire, if specified at time of order.

  • Basic units can accommodate 1,2,3 or 4 of option B or 1 or 2 of option C switches
  • Ultimate safety factor of all units is 2:1 (1.8:1 for metric capacities)
  • Cable should be IWRC (Independent Wire Rope Core) with as many strands as possible
  • Wire rope selection for any application for proper safety factor is a customer responsibility
  • Calibration performed with rope diameter specified at order
  • Available Capacities:
  • CGS-1: 2,500 lb | 1,250 kg
  • CGS-2: 5,000 lb | 2,500 kg
  • CGS-3: 10,000 lb | 5,000 kg
  • CGS-4: 20,000 lb | 10,000 kg

ForceControlSwitches_Brochure

Contact us  

  • Email
  • Phone
    281-405-0606
  • Fax
    281-405-0303
  • Address
    16515 Hedgecroft, Suite 320 Houston, TX 77060

Send us a message

Dynameasure.com © 2017. Web designed by +58 Digital Communications